LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Bumpers And Fascias) >> Repair Instructions >> Front Bumper End Cap Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Bumper End Cap
    GM851571Courtesy of GENERAL MOTORS CORP.
  1. Install the end cap to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolts to the end cap.

    Tighten:  Tighten the bolts to 8 N.m (71 lb in).

scientia non olet · About LEMON Manuals