LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor 2 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Knock Sensor Wiring Harness Electrical Connector
    GM1964987Courtesy of GENERAL MOTORS CORP.
  1. Remove the right front wheel and tire. Refer to Tire and Wheel Removal and Installation .
  2. Working through the wheel well opening, disconnect the engine wiring harness electrical connector (3) from knock sensor.
    3. Fig 2: Right Side Knock Sensor & Bolt
    GM1402140Courtesy of GENERAL MOTORS CORP.
  3. Remove the knock sensor bolt (739) and knock sensor (718).
scientia non olet · About LEMON Manuals