LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Draining

Fuel Tank Draining

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Fill Hose & Clamp
    GM1964118Courtesy of GENERAL MOTORS CORP.
  1. Loosen the fuel fill cap in order to relieve the fuel tank vapor pressure.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Loosen the fuel fill hose clamp (1).
  4. Remove the fuel fill hose from the fuel tank.
  5. Insert the hose from the pump devise into the fuel tank.
  6. Using a hand or air operated pump device, drain as much fuel from the tank as possible.