LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Pump Flow Control Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of ECBM Shield, Retainers & Bolts
    GM1964016Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the electronic brake control module (EBCM) shield retainers (2).
  3. Remove the EBCM shield bolts (3) and shield (1).
    4. Fig 2: Locating Chassis Wiring Harness Electrical Connector
    GM1911337Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the chassis wiring harness electrical connector (1) from the fuel pump flow control module.
    5. Fig 3: View Of Fuel Pump Flow Control Module & Bolts
    GM1911342Courtesy of GENERAL MOTORS CORP.
  5. Loosen the fuel pump flow control module bolts (1).
  6. Slide the fuel pump flow control module (2) towards the passenger side of the vehicle.
  7. Remove the fuel pump flow control module from the vehicle.
scientia non olet · About LEMON Manuals