LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Pump Flow Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Pump Flow Control Module & Bolts
    GM1911342Courtesy of GENERAL MOTORS CORP.
  1. Position the fuel pump flow control module (2) to the vehicle.
  2. Slide the fuel pump flow control module towards the driver side of the vehicle.
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the fuel pump flow control module bolts (1).

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    4. Fig 2: Locating Chassis Wiring Harness Electrical Connector
    GM1911337Courtesy of GENERAL MOTORS CORP.
  4. Connect the chassis wiring harness electrical connector (1) to the fuel pump flow control module.
    5. Fig 3: View Of EBCM Shield, Retainers & Bolts
    GM1964016Courtesy of GENERAL MOTORS CORP.
  5. Position the EBCM shield (1) to the underbody and install the EBCM shield bolts (3).

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  6. Install the EBCM shield retainers (2).
  7. Lower the vehicle.
  8. Program the fuel pump flow control module. Refer to Control Module References .
scientia non olet · About LEMON Manuals