LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Fuel Level Sensor Tangs & Retainer
    GM1704575Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank module. Refer to Fuel Tank Fuel Pump Module Replacement .
  2. Using a small pick like tool, push in the retainer (1) in order to disengage the electrical connector.
  3. Remove the fuel level sensor electrical connector from the module cover.
  4. Push the level sensor locking tangs (2) in towards the inside of the module bucket.
    5. Fig 2: View Of Fuel Level Sensor At Sending Unit Bucket (4.8L & 5.3L)
    GM1341846Courtesy of GENERAL MOTORS CORP.
  5. Slide the fuel level sensor up.
    6. Fig 3: View Of Fuel Level Sensor
    GM1704577Courtesy of GENERAL MOTORS CORP.
  6. Remove the fuel level sensor from the module.
scientia non olet · About LEMON Manuals