LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose/Pipes Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Clean the fuel feed line connection and surrounding area prior to disconnecting the fitting in order to avoid possible fuel system contamination.
    Fig 1: View Of EVAP Line Clip & Retainer
    GM1704504Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
  2. Remove the fuel feed line from the retaining feature (2) in the fuel tank.
  3. Open the fuel/evaporative emission (EVAP) line clip (1) and remove the fuel feed line from the clip.
  4. Disconnect the fuel feed line quick connect fitting at the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 2: View Of Fuel Feed Line
    GM1704506Courtesy of GENERAL MOTORS CORP.
  5. Remove the fuel feed line from the fuel tank.
  6. Cap the fuel feed port on the fuel tank module in order to prevent possible fuel system contamination.
scientia non olet · About LEMON Manuals