LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose/Pipes Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Feed Line
    GM1704506Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel feed line to the fuel tank.
  2. Remove the cap from the fuel feed port on the fuel tank module.
    3. Fig 2: View Of EVAP Line Clip & Retainer
    GM1704504Courtesy of GENERAL MOTORS CORP.
  3. Connect the fuel feed line quick connect fitting at the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Install the fuel feed line to the clip (1) and close the clip.
  5. Install the fuel feed line to the retaining feature (2) in the fuel tank.
  6. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals