LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission System Hoses/Pipes Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Pipe & Clips
    GM1965576Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP pipe (3) to the vehicle.
  2. Connect the EVAP pipe quick connect fitting to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Connect the EVAP pipe quick connect fitting to the auxiliary EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Install the EVAP pipe clip (1) to the rear brake front pipes.
  5. Install the EVAP pipe clip (2) to the frame crossmember.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals