LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Canister, Bracket & Bolt
    GM1964900Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister (2) to the bracket (3).
    2. NOTE: Refer to Fastener Notice .
  2. Install the EVAP canister bolt (1).

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: View Of EVAP Canister Assembly & Bolts
    GM1964898Courtesy of GENERAL MOTORS CORP.
  3. Position and install the EVAP canister assembly (2) to the fame bracket tab.
  4. Install the EVAP canister bolts (1).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    5. Fig 3: Locating Quick Connect Fittings
    GM1964897Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP pipe quick connecting fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Connect the fuel tank EVAP line quick connect fitting (2) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  7. Connect the fuel tank EVAP line quick connect fitting (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals