LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Perform the Crankshaft Position System Variation Learn whenever the crankshaft position sensor is removed or replaced.
    Fig 1: View Of Engine Wiring Harness Electrical Connector & Sleeve
    GM1964987Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Reposition the engine wiring harness sleeve (2).
  3. Disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.
    4. Fig 2: View Of CKP Sensor & Bolt
    GM1239292Courtesy of GENERAL MOTORS CORP.
  4. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
  5. Remove the CKP sensor bolt.
  6. Remove the CKP sensor.
scientia non olet · About LEMON Manuals