LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Element Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of MAF/IAT Sensor & Wiring Harness Electrical Connector
    GM1960228Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (2) from the mass air flow (MAF)/intake air temperature (IAT) sensor (1).
    2. Fig 2: View Of Air Cleaner Components
    GM1707476Courtesy of GENERAL MOTORS CORP.
  2. Loosen the 4 air cleaner housing screws.
  3. Lift up the air cleaner housing cover.
  4. Remove the air filter element.
scientia non olet · About LEMON Manuals