Electronic Suspension Front Position Sensor Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Position Sensor & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
1	Front Position Sensor Link Tip: Disconnect the link from the sensor ball stud.
2	Front Position Sensor Bolt Tip: Remove the bolt from the sensor. Tighten: 12 N.m (106 lb in)
3	Front Position Sensor Tip: Disconnect the electrical connector from the sensor.