LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Automatic Transmission - 2ML70 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Rear Case and Gasket Replacement (2WD)

Rear Case and Gasket Replacement (2WD)

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Case and Gasket Replacement (2WD)
GM1970171Courtesy of GENERAL MOTORS CORP.
Callout Component Name
NOTE: Use Dexron VI transmission fluid only. Failure to use the proper fluid may result in transmission internal damage.

Preliminary Procedures

  1. Remove the rear propeller shaft. Refer to Rear Propeller Shaft Replacement .
  2. Place a suitable drain pan under the transmission.
  3. Fill the transmission with the proper amount of transmission fluid. Refer to Fluid Capacity Specifications and Transmission Fluid Check .
1 Rear Case Bolt (Qty: 12)
NOTE: Refer to Fastener Notice .

Tighten:  27 N.m (20 lb ft)

2 Rear Case
3 Rear Case Gasket