LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Automatic Transmission - 2ML70 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Auxiliary Fluid Pump Control Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Auxiliary Fluid Pump Electrical Wire Harness Connector & Auxiliary Fluid Pump Control Module Connector
    GM1975037Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the auxiliary fluid pump electrical wire harness connector (1) from the auxiliary fluid pump control module connector (2).
    2. Fig 2: Auxiliary Fluid Pump Control Module Electrical Connector & Engine Wiring Harness Electrical Connector
    GM1975207Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the auxiliary fluid pump control module electrical connector (1) from the engine wiring harness electrical connector (2).
    3. Fig 3: Auxiliary Fluid Pump Control Module Electrical Connector
    GM1975204Courtesy of GENERAL MOTORS CORP.
  3. Remove the auxiliary fluid pump control module electrical connector (1) from the auxiliary fuse block.
  4. Remove the auxiliary fluid pump control module (2) from the engine control module bracket.
scientia non olet · About LEMON Manuals