LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Automatic Transmission - 2ML70 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Range Selector Lever Cable Heat Shield Bolts & Range Selector Lever Cable Heat Shield
    GM1970183Courtesy of GENERAL MOTORS CORP.
  2. Remove the range selector lever cable heat shield bolts (1).
  3. Remove the range selector lever cable heat shield (2).
    4. Fig 2: Range Selector Lever Cable
    GM1970184Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the range selector lever cable (2) from the range select lever.
  5. Remove the range selector lever cable retainer (1).
  6. Remove the range selector lever cable (2) from the cable bracket.
    7. Fig 3: Range Selector Lever Nut
    GM1970155Courtesy of GENERAL MOTORS CORP.
  7. Remove the range selector lever nut (1).
  8. Remove the range selector lever (2).
scientia non olet · About LEMON Manuals