LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Automatic Transmission - 2ML70 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Range Selector Lever
    GM1970155Courtesy of GENERAL MOTORS CORP.
  1. Install the range selector lever (2).
  2. Install the range selector lever nut (1).
    NOTE: Refer to Fastener Notice .

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

    3. Fig 2: Range Selector Lever Cable
    GM1970184Courtesy of GENERAL MOTORS CORP.
  3. Install the range selector lever cable (2) to the cable bracket.
  4. Install the range selector lever cable retainer (1).
  5. Connect the range selector lever cable (2) to the range select lever.
    6. Fig 3: Range Selector Lever Cable Heat Shield
    GM1970183Courtesy of GENERAL MOTORS CORP.
  6. Install the range selector lever cable heat shield (2).
  7. Install the range selector lever cable heat shield bolts (1).

    Tighten:  Tighten the bolts to 17 N.m (13 lb ft).

  8. Lower the vehicle.
scientia non olet · About LEMON Manuals