Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The auxiliary fluid pump gasket is not re-usable. Use a NEW gasket when replacing or damage may occur.

Install the auxiliary fluid pump gasket (3).

NOTE: Do not damage the case sealing surface when removing or installing the pump and motor assembly.

Install the auxiliary fluid pump (2).

Fig 1: Auxiliary Fluid Pump Gasket, Pump & Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the auxiliary fluid pump bolts (1).
Tighten: Tighten the bolts to 9-13 N.m (80-115 lb in).
Install the auxiliary fluid pump wire harness clip nut (3).
Tighten: Tighten the nuts to 9 N.m (80 lb in).
Lower the vehicle.
Install the auxiliary fluid pump wire harness (6) to the harness retainers (7).

Fig 2: Bolts, Control Module Connector, Clip Nut, Wire Harness & Retainers

Courtesy of GENERAL MOTORS CORP.

Connect the auxiliary fluid pump wire harness (1) to the auxiliary fluid pump control module connector (2).

NOTE: Use Dexron VI transmission fluid only. Failure to use the proper fluid may result in transmission internal damage.

Fill the transmission with the proper amount of transmission fluid. Refer to Fluid Capacity Specifications and Transmission Fluid Check .