Holding Fixture Installation and Torque Dampener Removal

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Holding Fixture Installation and Torque Dampener

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	A/Trans Torque Dampener Assembly
2	A/Trans Case Assembly Procedure Rotate the transmission so that the damper housing is up and secure with locking pin. Allow any remaining transmission fluid to drain from the case extension. Special Tools DT-48307 Holding Fixture. See Special Tools . J 3289-20 Holding Fixture Base Assembly

Callout

Component Name

A/Trans Torque Dampener Assembly

A/Trans Case Assembly

Procedure

Rotate the transmission so that the damper housing is up and secure with locking pin.
Allow any remaining transmission fluid to drain from the case extension.

Special Tools

DT-48307 Holding Fixture. See Special Tools .
J 3289-20 Holding Fixture Base Assembly