Fluid Pump Cover Installation

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fluid Pump Cover

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	A/Trans Fluid Pump Cover Assembly Tip: Align pump with guide pins on the torque dampener housing.
2	A/Trans Fluid Pump Cover Bolts M6 x1.0 x 45 (Qty: 18) NOTE: Refer to Fastener Notice . Procedure:: Tighten in sequence shown. Tighten: 9-13 N.m (80-115 lb in)