Drive Motor with Generator Assembly Removal - 2nd Position

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Drive Motor with Generator Assembly - 2nd Position

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Generator Drive Motor Bolt M6 x 1.0 x 20.0 (Qty: 3) Tip: Remove only the three bolts on the motor that are indicated.
2	Drive Motor (w/Generator) Assembly - 2nd Position CAUTION: The generator motor weighs approximately 36 kg (80 lbs). Personal injury may result if you lift the generator motor improperly. NOTE: Set drive generator motor on its side to avoid damaging the electrical connectors. Tip: Ensure the DT-48473 is completely seated and locked on the motor assembly and ensure legs are bolted tight. See Special Tools . It will require the use of an overhead chain fall to remove. The O-Ring seals are not reusable. Special Tool: DT-48473 Motor Lift Plate. See Special Tools .

Callout

Component Name

Generator Drive Motor Bolt M6 x 1.0 x 20.0 (Qty: 3)
Tip: Remove only the three bolts on the motor that are indicated.

Drive Motor (w/Generator) Assembly - 2nd Position

CAUTION: The generator motor weighs approximately 36 kg (80 lbs). Personal injury may result if you lift the generator motor improperly.

NOTE: Set drive generator motor on its side to avoid damaging the electrical connectors.

Tip: Ensure the DT-48473 is completely seated and locked on the motor assembly and ensure legs are bolted tight. See Special Tools . It will require the use of an overhead chain fall to remove. The O-Ring seals are not reusable.
Special Tool:
DT-48473 Motor Lift Plate. See Special Tools .