Drive Motor with Generator Assembly Installation - 1st Position
WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Drive Motor (w/Generator) Assembly - 1st Position
CAUTION:
The generator motor weighs approximately 36 kg (80 lbs). Personal injury may result if you lift the generator motor improperly.
NOTE:
Carefully feed temp sensor and resolver connector thru case opening or damage may occur. Tip: Replace with NEW seals while motor is on holding fixture. |
| 2 | Generator Drive Motor Bolt M6 x 1.0 x 20 (Qty: 3)
NOTE:
Refer to Fastener Notice
. Tip: Use trans assembly gel on O-rings for motor. Tighten: Tighten bolt to 9-13 N.m (80-115 lb in). Special Tool: DT-48473 Motor Lift Plate. See Special Tools . |