Control Valve Assembly Removal
WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Control Solenoid (w/Body and TCM) Valve Assembly Procedure: Disconnect the wiring harness. |
| 2 | Shift Shaft Position Switch Procedure: Disconnect the wiring harness. |
| 3 | A/Trans Wiring Harness Assembly Procedure: Disconnect the wiring harness. |
| 4 | Control Valve Upper Body Bolt M6 x1.0 x 65 (Qty: 4) Tip: Do not remove all the bolts in the control valve body assembly. Remove only the bolts indicated. |
| 5 | Control Valve Upper Body Bolt M6 x 1.0 x 80 (Qty: 2) |
| 6 | Control (w/Body and Valve) Valve Assembly
NOTE:
Use care when handling the control valve body assembly. If dropped, damage to the control solenoid valve body assembly internal components, including the transmission control module (TCM), may result.
|
| 7 | A/Trans Fluid Pump Seal Assembly Tip: Do not reuse the seal assembly. |
| 8 | Hybrid Low, 1-2 Clutch Regulator Valve Seal (Qty: 6) Tip: Do not reuse the seal assembly. |