Control Valve Assembly Installation
WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Control Valve Upper Body Seal (Qty: 6) Tip: Install a NEW seal. |
| 2 | A/Trans Fluid Pump Seal Assembly Tip: Install a NEW seal assembly. |
| 3 | Control (w/Body and Valve) Valve Assembly Tip: Align the manual shift shaft position switch activator slide with the detent lever guide pin. |
| 4 | Control Valve Upper Body Bolts M6 x1.0 x 65 (Qty: 4)
NOTE:
Refer to Fastener Notice
. Procedure: Tighten in the sequence shown. Tighten: 9-13 N.m (80-115 lb in) |
| 5 | Control Valve Upper Body Bolt M6 x 1.0 x 80 (Qty: 2) |
| 6 | Manual Shift Detent Assembly |
| 7 | Manual Shift Detent Spring Bolt M6 x 1.0 x 16 Tighten: 9-13 N.m (80-115 lb in) |
| 8 | Control Solenoid (w/Body and TCM) Valve Assembly Procedure: Connect the wiring harness. |
| 9 | Shift Shaft Positon Switch Procedure: Connect the wiring harness. |
| 10 | A/Trans Wiring Harness Assembly Procedure: Connect the wiring harness. |