Valve Assembly to Transfer Plate Assemble
WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
Valve Assembly to Transfer Plate Assemble
| Callout | Component Name |
|---|---|
| 1 | A/Trans Fluid Pump Ball Check Valve Tip: Clean and inspect the ball check valve and install. Refer to Ball Check Valve Locations . |
| 2 | Control Valve Body Spacer (w/Gasket) Plate Assembly
NOTE:
Do not use the old spacer plate. Install a NEW spacer plate. Reusing an old spacer plate may cause internal transmission leaks and transmission damage.
|
| 3 | Control Valve Channel Plate Tip: Turn the valve body assembly over after installing to the upper body. |
| 4 | Control Valve Channel Plate Bolt M6 x1.0 x 35 (Qty: 3) Tip: Hand tighten only. |