LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Automatic Transmission - 2ML70 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Control Valve Assembly Assemble >> Control Solenoid (w/Body and TCM) Valve Installation

Control Solenoid (w/Body and TCM) Valve Installation

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Control Solenoid (w/Body and TCM) Valve
GM1867838Courtesy of GENERAL MOTORS CORP.
Control Solenoid (w/Body and TCM) Valve Installation

Callout Component Name
1 Control Solenoid (w/Body and TCM) Valve Assembly
Tip:  Note the locator pin on the control valve lower body assembly while aligning the control solenoid valve assembly.
2 Control Solenoid Valve Heat Sink (w/Body and TCM) Bolt M5 x.8 x 53 (Qty: 2)
Tip:  Hand tighten only.
3 Control Valve Lower Body Bolt M6 x1.0 x 55 (Qty: 9)
Tip:  Hand tighten only.
scientia non olet · About LEMON Manuals