Pressure Control (PC) Solenoid 3 Trim
WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
The PC solenoid 3 trim defaults to its normally high state (ON) allowing actuator feed limit fluid to enter the PCS 3 signal circuit. PCS 3 signal fluid is then routed through orifice #34 to the hybrid low, 1-2 clutch regulator valve; through orifice #33 to the hybrid low, 1-2 clutch boost valve; and to the shift solenoid valve - mode B.