LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 225 (HVAC System - Automatic) >> Repair Instructions >> Auxiliary Mode Valve Actuator Replacement (Delphi)

Auxiliary Mode Valve Actuator Replacement (Delphi)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Auxiliary Mode Valve Actuator (Delphi)
GM1681981Courtesy of GENERAL MOTORS CORP.
Callout Component Name
NOTE: In order to avoid actuator damage, DO NOT apply power to the actuator when it is not installed in the HVAC module.

Preliminary Procedure

  1. Remove the right rear quarter trim panel. Refer to Rear Quarter Trim Panel Replacement - Right Side (Standard Wheelbase) or Rear Quarter Trim Panel Replacement - Right Side (Extended Wheelbase) .
  2. Disconnect the electrical connector from the mode actuator.
1 Mode Actuator Screw - Auxiliary (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  2.5 N.m (16 lb in)

2 Mode Actuator - Auxiliary
Procedure: 
Re-calibrate the mode actuator. Refer to Actuator Recalibration .