Heater Core Coolant Pump W/HP2
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
The primary purpose of the heater core coolant pump is to circulate engine coolant through the HVAC heater core when heat is required in the cabin for comfort. This normally happens when the vehicle is in an Auto Stop and the mechanical pump is not spinning. If the HVAC control module has determined heat is needed for the cabin, this pump is turned on once the engine is shut off so the customer does not notice a change in heater duct discharge temperatures. The HVAC control module controls the auxiliary cooland pump relay via the heater core coolant pump relay control circuit. Heater core coolant pump relay supplies B+ voltage to the heater core coolant pump.