LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Hybrid Engine Control System) >> Diagnostic Information and Procedures >> DTC P06B1, P06B2, P06B4, or P06B5 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clear the DTC and operate the vehicle under the condition for running and setting the DTC.
  2. Shut the ignition OFF for 30 seconds, and verify that the DTC does not reset.
    • If the DTC resets, replace the PIM.
scientia non olet · About LEMON Manuals