LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Oil Pressure Sensor & Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pressure Sensor, Washer & Valve Lifter Oil Filter
    GM1402008Courtesy of GENERAL MOTORS CORP.
  1. Apply sealant to the threads of the NEW oil pressure sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers .
    2. NOTE: Refer to Fastener Notice .
  2. If equipped with active fuel management perform the following step, using J 41712  or equivalent. See Special Tools . Install the oil pressure sensor (706) and washer (707).

    Tighten:  Tighten the sensor to 35 N.m (26 lb ft).

    3. Fig 2: View Of Oil Pressure Sensor & Washer
    GM1403317Courtesy of GENERAL MOTORS CORP.
  3. If not equipped with active fuel management, perform the following step, using J 41712  or equivalent. See Special Tools . Install the oil pressure sensor (706) and washer (707).
    4. Fig 3: View Of Engine Harness Electrical Connectors & Inlet Hose Clamp
    GM1697098Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine harness electrical connector (1) to the oil pressure sensor.

    Tighten:  Tighten the sensor to 35 N.m (26 lb ft).

  5. Install the intake manifold. Refer to Intake Manifold Replacement (RPOs LY2/LY6)  or Intake Manifold Replacement (RPOs LC9/LMG/LY5/L76)  or Intake Manifold Replacement (RPO L92 - First Design)  or Intake Manifold Replacement (RPO L92 - Second Design) .
scientia non olet · About LEMON Manuals