LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Oil Level Sensor & Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Level Sensor
    GM260123Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the oil level sensor to the oil pan.

    Tighten:  Tighten the sensor to 20 N.m (15 lb ft).

    2. Fig 2: View Of Engine Wiring Harness Electrical Connector & Components
    GM1698087Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine harness electrical connector (4) to the oil level sensor.
    3. Fig 3: View Of Oil Pan Drain Plug & Seal
    GM1658109Courtesy of GENERAL MOTORS CORP.
  3. Ensure that the oil pan drain plug is tight.

    Tighten:  Tighten the drain plug to 25 N.m (18 lb ft).

  4. Lower the vehicle.
  5. Fill the engine with NEW engine oil. Refer to Fluid and Lubricant Recommendations and Approximate Fluid Capacities .
  6. Start the engine and inspect for leaks.
scientia non olet · About LEMON Manuals