LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Fixed And MOVEABLE Windows) >> Repair Instructions >> Windshield Side Reveal Molding Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the windshield reveal molding to the windshield pillar.
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
    Fig 1: Windshield Reveal Molding & Windshield Pillar
    GM870622Courtesy of GENERAL MOTORS CORP.
  2. Install the screws to the windshield reveal molding.

    Tighten:  Tighten the screws to the windshield reveal molding to 2 N.m (18 lb in).

  3. Install the front door sealing weatherstrip (1) to the pinchweld.
  4. Close the door.
scientia non olet · About LEMON Manuals