Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- With the window in the full up position, position the stabilizer (2) in place inside the door.
- Install the fastener (1) retaining the stabilizer to the door.
Tighten: Tighten the fasteners to 9 N.m (7 lb ft).
- Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
- Install the door trim panel. Refer to Front Side Door Trim Panel Replacement
NOTE:
Refer to Fastener Notice
.