LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Fixed And MOVEABLE Windows) >> Repair Instructions >> Rear Side Door Window Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Rear Door Window Clamps
    GM838833Courtesy of GENERAL MOTORS CORP.
  1. Slide the window through the opening at the bottom of the window frame into position in the window clamps (1).
  2. Install the sealing strip. Refer to Rear Door Window Belt Inner Sealing Strip Replacement .
    3. NOTE: Refer to Fastener Notice .
  3. Install the run channel. Refer to Rear Side Door Window Channel Replacement .

    Tighten:  Tighten the clamps to 9 N.m (6 lb ft).

  4. Install the stabilizer. Refer to Rear Side Door Window Stabilizer Replacement .
  5. Operate the window to ensure proper operation.
  6. Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
  7. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals