LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Fixed And MOVEABLE Windows) >> Repair Instructions >> Rear Side Door Window Channel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the window in the full up position, position the run channel (2) in place inside the door.
    2. NOTE: Refer to Fastener Notice .
  2. Install the fasteners (1) retaining the run channel to the door.

    Tighten:  Tighten the fasteners to 9 N.m (6 lb ft).

    3. Fig 1: Rear Door Window Run Channel
    GM839203Courtesy of GENERAL MOTORS CORP.
  3. Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
  4. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals