LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Fixed And MOVEABLE Windows) >> Repair Instructions >> Rear Lift Window Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows .
    2. Fig 1: Identifying Rear Lift Window
    GM870674Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the window defogger on the window, if equipped.
    3. Fig 2: Identifying Rear Liftgate Window Defogger Connectors
    GM379401Courtesy of GENERAL MOTORS CORP.
  3. Install the window garnish molding to the door frame.
  4. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
scientia non olet · About LEMON Manuals