LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Fixed And MOVEABLE Windows) >> Repair Instructions >> Quarter Window Replacement (SUT Body Side Window) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the quarter window into the opening. Refer to Urethane Adhesive Installation of Encapsulated Stationary Windows .
    2. Fig 1: Quarter Window
    GM1412544Courtesy of GENERAL MOTORS CORP.
  2. Ensure the pinchweld is primed properly.
  3. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
  4. Reposition the midgate window weatherstrip to the pinchweld flange.
  5. Install the rear lock pillar garnish molding. Refer to Lock Pillar Upper Garnish Molding Replacement .
  6. Close the midgate.
  7. Install the rear header garnish molding. Refer to Roof Rear Header Garnish Molding Replacement .
  8. Install the rear sail panel molding. Refer to Sail Panel Molding Replacement (Left Side) .
scientia non olet · About LEMON Manuals