LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Fixed And MOVEABLE Windows) >> Repair Instructions >> Midgate Window Regulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Midgate Window Regulator Components
    GM986408Courtesy of GENERAL MOTORS CORP.
  1. Install the window regulator to the midgate.
  2. Connect the window regulator electrical connector (1).
    3. Fig 2: Midgate Window Regulator
    GM1477813Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the nuts retaining the window regulator to the midgate.

    Tighten:  Tighten the window regulator nuts to 25 N.m (18 lb ft).

  4. Install the midgate window. Refer to Midgate Window Replacement .
  5. Inspect and adjust the midgate window alignment to the weatherstrip channel. Refer to Midgate Window Replacement .
  6. Install the midgate inner panel. Refer to Midgate Inner Panel Replacement .
scientia non olet · About LEMON Manuals