LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Fixed And MOVEABLE Windows) >> Repair Instructions >> Midgate Window Outer Sealing Strip Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the center lower interior trim. Refer to Endgate Center Molding Replacement .
    2. Fig 1: Supporting Midgate
    GM1236621Courtesy of GENERAL MOTORS CORP.
  2. Lower the window into the midgate.
  3. Release the midgate latches, opening the midgate until the holes in the hinge assembly are aligned.
  4. Install 5 mm (0.20 in) pins (2) or an allen wrench through the holes in each hinge (1) to support the midgate.
    5. Fig 2: Midgate Window Sealing Strip
    GM1412506Courtesy of GENERAL MOTORS CORP.
  5. Remove the fasteners securing the sealing strip to the midgate structure.
  6. Begin at either end and gently pry upward in order to release the sealing strip from the midgate structure.
  7. Remove the sealing strip from the midgate and discard if damaged.
scientia non olet · About LEMON Manuals