LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Fixed And MOVEABLE Windows) >> Repair Instructions >> Midgate Window Outer Sealing Strip Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Midgate Window Sealing Strip
    GM1412506Courtesy of GENERAL MOTORS CORP.
  1. Align the tab on the midgate window sealing strip to the notch in the midgate flange.
  2. Install the window sealing strip to the midgate flanges, pressing down until the seal is fully seated.
    3. NOTE: Refer to Fastener Notice .
  3. Install the sealing strip screws.

    Tighten:  Tighten the screws to 0.675 N.m (6 lb in).

    4. Fig 2: Supporting Midgate
    GM1236621Courtesy of GENERAL MOTORS CORP.
  4. Remove the pins (2) or allen wrenches from the midgate hinges (1) supporting the midgate.
  5. Close the midgate, ensuring the latches are fully engaged.
  6. Install the center lower interior trim. Refer to Endgate Center Molding Replacement .
  7. Close the midgate window. Ensure the window sealing strip remains fully seated and not binding against the midgate window.
scientia non olet · About LEMON Manuals