LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Fixed And MOVEABLE Windows) >> Repair Instructions >> Front Side Door Window Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the trim panel. Refer to Front Side Door Trim Panel Replacement .
  2. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
  3. Position the window in a position that allows access to the window clamp bolts.
    4. Fig 1: Front Power Window Module
    GM838386Courtesy of GENERAL MOTORS CORP.
  4. Loosen the fasteners on the window clamps.
  5. Position the window in the full up position and tape in place.
  6. Disconnect the window motor electrical connector.
  7. Remove the 5 fasteners (1) retaining the window module to the door.
  8. Remove the window module from the door.
scientia non olet · About LEMON Manuals