LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (Wheel Drive Shafts) >> Diagnostic Information and Procedures >> Click Noise In Turns

Click Noise In Turns

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Step Action Yes No
DEFINITION: Clicking noise while turning in drive under load.
1 Check for worn or damaged outer CV joints.
Are the outer CV joints/seals worn?		 Go to Step 2  System OK
2 Replace the outer CV joints/seals. Refer to Wheel Drive Shaft Outer Joint and Boot Replacement .
Is the repair complete?		 System OK -
scientia non olet · About LEMON Manuals