LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Power Steering System) >> Repair Instructions >> Steering Linkage Inner Tie Rod Replacement (Standard) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: All threads must be clean prior to LOCTITE® application. Check the LOCTITE®, or equivalent, container for the expiration date. Use only enough LOCTITE® to evenly coat the threads.
  1. Apply LOCTITE® 262, or equivalent, to the steering gear inner tie rod threads.
  2. Attach the steering linkage inner tie rod onto the steering gear rack.
    3. Fig 1: View Of Steering Gear Rack & Steering Linkage Inner Tie Rod
    GM1751747Courtesy of GENERAL MOTORS CORP.
  3. Place a pipe wrench on the flats on the steering gear rack (1) next to the steering linkage inner tie rod (2).
    4. NOTE: Refer to Fastener Notice .
  4. Tighten the steering linkage inner tie rod (2).

    Tighten:  Tighten the steering linkage inner tie rod to 150 N.m (111 lb ft).

  5. Install the steering gear boot. Refer to Steering Gear Boot Replacement - On Vehicle .
scientia non olet · About LEMON Manuals