LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Power Steering System) >> Repair Instructions >> Steering Gear Pitman Shaft Seal and Bearing Replacement - Off Vehicle >> Disassembly Procedure

Disassembly Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering gear. Refer to Steering Gear Replacement (Rack and Pinion)  or Steering Gear Replacement (Non-Rack and Pinion)  or Steering Gear Replacement (Two Mode Hybrid) .
    2. Fig 1: View Of Pitman Arm, Shaft Boot, Shaft Dust Seal & Steering Gear Housing
    GM740399Courtesy of GENERAL MOTORS CORP.
  2. Remove the steering gear pitman shaft and housing cover. Refer to Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle .
  3. Remove the pitman arm (4) from the steering gear (1). Refer to Pitman Arm Replacement .
  4. Remove the pitman arm boot (3) from the steering gear housing (1).
    5. IMPORTANT: Do not score the steering gear housing bore when prying out the seals and washers.
  5. Remove the dust seal (2) from the steering gear housing (1).
    6. Fig 2: View Of Pitman Shaft Retaining Ring & Steering Gear Housing
    GM412380Courtesy of GENERAL MOTORS CORP.
  6. Remove the steering gear pitman shaft seal retaining ring (2) from the steering gear housing (1) using pliers J 4245  . See Special Tools .
    7. Fig 3: Identifying Steering Gear Housing, Pitman Shaft Seal & Pitman Shaft Washer
    GM412382Courtesy of GENERAL MOTORS CORP.
  7. Remove the steering gear pitman shaft washer (3) from the steering gear housing (1).
  8. Pry the steering gear pitman shaft seal (2) from the steering gear housing (1) using a screwdriver.
  9. Inspect the housing for burrs and replace if necessary.
    10. Fig 4: View Of Needle Bearing & Steering Gear Housing
    GM412383Courtesy of GENERAL MOTORS CORP.
  10. Insert remover/installer J 6278  through the hole in the top of the steering gear housing (1). See Special Tools .
  11. Drive out the steering gear pitman shaft bearing (2) from the steering gear housing (1).
scientia non olet · About LEMON Manuals