LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Power Steering System) >> Repair Instructions >> Steering Gear Cylinder Pipe Assembly & Seals Replacement - Off Vehicle >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering gear. Refer to Steering Gear Replacement (Rack and Pinion)  or Steering Gear Replacement (Non-Rack and Pinion)  or Steering Gear Replacement (Two Mode Hybrid) .
    2. Fig 1: View Of Cylinder Line Retaining Plate & Bolt
    GM1751420Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Protect the steering gear boots from sharp tools and from the sharp edges of surrounding components.
  2. Remove the power steering gear inlet hose retaining plate bolt (1) and the power steering gear inlet hose retaining plate (2).
    3. Fig 2: Identifying Steering Gear Cylinder Pipe Seals, Pipes, Pipe Fittings & Steering Gear
    GM1989785Courtesy of GENERAL MOTORS CORP.
  3. Loosen both steering gear cylinder pipe fittings (3) on the steering gear (4).
  4. Remove both steering gear cylinder pipes (2) from the steering gear (4).
  5. Remove and discard the steering gear cylinder pipe seals (1) from the steering gear (4).
scientia non olet · About LEMON Manuals