LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Power Steering System) >> Repair Instructions >> Power Steering Pump Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power steering pump from the vehicle. Refer to Power Steering Pump Replacement (4.8L, 5.3L, 6.0L, and 6.2L) .
    2. Fig 1: View Of Power Steering Pump & Shaft Seal
    GM1555824Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Use the shim stock in order to protect the drive shaft.
  2. Use a chisel in order to cut and remove the power steering pump shaft seal.
scientia non olet · About LEMON Manuals