LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Power Steering System) >> Repair Instructions >> Power Steering Fluid Reservoir Replacement - Off Vehicle >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Reservoir O-Ring Seals, Magnet & Pump Housing
    GM404947Courtesy of GENERAL MOTORS CORP.
  1. Clean and install the power steering fluid reservoir magnet (3).
  2. Install the power steering pump seals (1, 4, 5) to the power steering pump (2).
    3. Fig 2: View Of Power Steering Fluid Reservoir & Pump
    GM404931Courtesy of GENERAL MOTORS CORP.
  3. Connect the power steering fluid reservoir (1) and the power steering pump (2).
    4. Fig 3: View Of Power Steering Pump Flow Control Valve, Control Valve Spring & Assembly
    GM404928Courtesy of GENERAL MOTORS CORP.
  4. Install the power steering pump flow control valve spring (3) and the power steering pump flow control valve (2) to the power steering pump assembly (1).
    5. Fig 4: View Of Pump Housing, Mounting Studs, O-Ring Seal & Connector/Fitting Assembly
    GM404915Courtesy of GENERAL MOTORS CORP.
  5. Install the power steering pump fitting seal (3) to the power steering pump assembly (1).
    6. NOTE: Refer to Fastener Notice .
    IMPORTANT: Start the power steering fluid reservoir studs and the power steering pump flow control valve fitting by hand before finalizing any torques.
  6. Install the power steering pump fitting (4) to the power steering pump assembly (1).

    Tighten:  Tighten the fitting to 75 N.m (55 lb ft).

  7. Install the power steering fluid reservoir studs (2) to the power steering pump assembly (1).

    Tighten:  Tighten the studs to 58 N.m (44 lb ft).

  8. Install the power steering pump assembly to the vehicle. Refer to Power Steering Pump Replacement (4.8L, 5.3L, 6.0L, and 6.2L) .
scientia non olet · About LEMON Manuals