LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Power Steering System) >> Repair Instructions >> Power Brake Booster Outlet Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place drain pans under the vehicle as needed.
  2. Remove as much power steering fluid from the power steering fluid reservoir as possible.
    3. Fig 1: View Of Power Brake Booster, Outlet Hose & Reservoir
    GM650861Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Power Steering Hose Disconnected Notice .
  3. Disconnect the power brake booster outlet hose (1) from the power brake booster (2).
  4. Disconnect the power brake booster outlet hose (1) from the power steering fluid reservoir (3).
  5. Remove the power brake booster outlet hose (1) from the vehicle.
scientia non olet · About LEMON Manuals