LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Power Steering System) >> Repair Instructions >> Power Brake Booster Inlet Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Brake Booster, Inlet Hose & Power Steering Pump
    GM650858Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Installing Hoses Without Twists Or Bends Notice .
  1. Install the power brake booster inlet hose (1) to the vehicle.
    2. NOTE: Refer to Fastener Notice .
    IMPORTANT: Start both power brake booster inlet hose fittings by hand before finalizing torques.
  2. Connect the power brake booster inlet hose (1) to the power brake booster (2).

    Tighten:  Tighten the fitting to 32 N.m (24 lb ft).

  3. Connect the power brake booster inlet hose (1) to the power steering pump (3).

    Tighten:  Tighten the fitting to 32 N.m (24 lb ft).

  4. Clean any excess fluid from the vehicle and remove the drain pans.
  5. Install the engine shield. Refer to Engine Shield Replacement .
  6. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals